Panasonic AJ-HPD2500 Operating Instructions - Page 159
Setting up for Playback, Adding shot marks to clips, Setting playback format PB FORMAT
View all Panasonic AJ-HPD2500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 159 highlights
AVCHD Recording and Playback USER CLIP NAME to be recorded • When clip metadata is loaded TYPE1: TYPE2: Loaded data Loaded data + counter value*1 4 Press the up and down (4/5) cursor buttons to select playback format and press the SET button. • When clip metadata is not loaded or when loaded clip metadata is not to be recorded TYPE1: TYPE2: A 5-digit serial number assigned in shooting order A 5-digit serial number assigned in shooting order *1:The counter value is indicated as a four-digit number. The counter value is incremented by 1 each time a clip is played back when clip metadata is loaded and recording method TYPE2 is set for recording metadata. Use the following procedure to reset the counter value. Press the MENU button, choose [META DATA] - [CLIP COUNT RESET] - [YES] and press the SET button to reset the counter value to 1. Adding shot marks to clips Adding shot marks (M) makes it easier to find desired clip. 1 Press the cursor buttons to move the yellow frame to the clip to which you will add a shot mark. 2 Press the MARKER (SHIFT + TEXT MEMO) button. To cancel a shot mark, repeat the above operation. • Available formats (When SYSTEM FREQ is set to 59.94 Hz) 1080/60i(30P), 1080/24P, 720/60P(30P), 720/24P (When SYSTEM FREQ is set to 50 Hz) 1080/50i(25P), 720/50P(25P) 5 Press the MENU button to return to the thumbnail screen. Clips with black numbers can be played while clips with red numbers cannot be played back. Switching to the normal mode will replace a set playback format with a playback format set by the setup menu No. 020 (SYS FORMAT). Repeat playback (REPEAT PLAY) When setup menu No. 160 (REPEAT PLAY) is set to ON, all playable clips will be played continuously. ➝Refer to "Setup" (page 164). Setting up for Playback Resume playback (RESUME PLAY) Set playback format and playback type. Setting playback format (PB FORMAT) Use the steps below to set playback format. ➝Refer to "Menu Operations" (page 38). 1 Press the MENU button. 2 Select [PLAY SETUP] and press the SET button. 3 Select [PB FORMAT] and press the SET button. Resume play starts playback from where it was last interrupted. 1 Press the MENU button. 2 Select [PLAY SETUP] and press the SET button. 3 Select [RESUME PLAY] and press the SET button. 4 Select [ON] and press the SET button. 5 Press the MENU button to return to the thumbnail screen. 6 Select clip to play back. When playback is interrupted, the resume play indicator appears on the clip thumbnail and playback continues from this point the next time playback is started. 159 AVCHD Recording and Playback: Using an Optional AVCHD Board