Panasonic AJ-HPD2500 Operating Instructions - Page 97
Revising IN and OUT points for the player, and recorder, Preview and assigning events when
View all Panasonic AJ-HPD2500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 97 highlights
Revising IN and OUT points for the player and recorder Preview and assigning events (when the player is a P2 card) After setting the IN or OUT point, preview to check edit result on the recorder. 3 1 2 Editing 2,3,4 3 4 1 Switch to player or recorder operation. Press the PLAYER button to switch to player or recorder operation. 2 Use the GOTO button and the IN or OUT button to find the IN or OUT point. Hold down the IN or OUT button and press the GOTO button to move the playback location to the IN or OUT point. 3 Set the IN or OUT point of the player or recorder. While looking at the player or recorder screen, hold down the IN or OUT button and press the ENTRY button to set the IN or OUT point again. Or hold down the IN or OUT button and press the RESET button to cancel the IN or OUT point. 4 Move the IN or OUT point of the player or recorder as necessary. To fine adjust, hold down the IN or OUT button and press the TRIM+ or TRIM- button to move the IN or OUT point. Hold down the button for 1 second or more to make continuous settings. 1 1 Press the PREVIEW button to preview. Start preview by pressing the PREVIEW button to play back the edited section on the recorder starting 3 seconds before the beginning of the edit section (PREROLL TIME setting) to 1 second beyond the end of the section. 2 The result is assigned as events to the timeline. ◆ NOTE: • To end preview, press the STOP button. • The audio level for each event can be separately set during preview. ➝ Refer to "Setting Audio Level" (page 109). • To confirm the edit result without previewing it, press the REC button. • Setting the OUT point for the recorder during preview stops preview and newly starts editing with the set OUT point. • When only the IN points for the player and the recorder are set, you can edit up to the end of the player clip, which becomes the OUT point for the player. • When no other operation has been performed after confirming an edit, a second preview will play back the section edited immediately before. The audio level for this section can then be adjusted. This level is cancelled if an IN or OUT point is set or event operations are performed. Editing: Creating Playlists 97