Ricoh 2051 Operating Instructions - Page 144

User Tools (Copier/Document Server Features) ❖ SADF Auto Reset In SADF mode, an original must be set within a specific time after the previous original has been fed. You can adjust this time from 3 seconds to 99 in 1 second increments. Note ❒ Default: 5 seconds ❖ Rotate Sort: Auto Paper Continue You can continue copying when paper of the required orientation has run out during rotate-sorting. See p.34 "Rotate Sort". ❖ Memory Full Auto Scan Restart If memory becomes full while scanning originals, the machine will copy the scanned originals first, and then automatically proceed scanning remaining originals. You can enable or disable this function. Note ❒ If you select [No] : • When memory becomes full, the machine stops operation, allowing you to remove the copies on the output tray. Note ❒ If you select [Yes] : ❒ If you select [No] : 5 • When paper of the required • You can leave the machine unattended to make copies, orientation runs out, the ma- but sorted pages will not be chine stops copying and sequential. prompts you to supply copy paper. When you load paper, ❒ Default: No the machine will continue ❖ Select Stapling Position (Top Left) copying. Specify which the type of stapling ❒ If you select [Yes] : • Copying continues using to be shown on the top left key of the initial display. copy paper of a different ori- entation. The copy job will finish even if the machine is left unattended. ❒ Default: No Note ❖ Auto Sort ❒ Default: Top You can specify whether the Sort function is to be selected when the machine is turned on, or when the functions are cleared. Note ❒ Default: No ❒ The optional finisher is required to use this function. ❖ Select Stapling Position (Bottom Left) Specify which the type of stapling to be shown on the bottom left key of the initial display. 134