Ricoh 2051 Operating Instructions - Page 25

Placing Originals Placing Originals on the Exposure Glass Reference For related default settings, see p.135 "Eject Copy Face Up/Down in Glass Mode". A Lift the exposure glass cover or the ADF. Important ❒ Do not lift the exposure glass cover or the ADF forcefully. Otherwise, the ADF cover might open or be damaged. Note ❒ Be sure to lift the exposure glass cover or ADF more than 30°. Otherwise, the size of the original might not be detected correctly. B Place the original face down on the exposure glass. It should be aligned with the rear left corner. 1. Positioning mark 2. Scale Note ❒ Start with the first page to be copied. C Lower the exposure glass cover or ADF. Placing Originals in the Auto Document Feeder Settings should be made accordingly 1 in the following situations: ❖ When placing originals consisting of more than 100 pages: p.16 "Batch" ❖ When placing originals one by one: p.17 "SADF" ❖ When placing originals of the same width but different sizes: p.17 "Placing originals of mixed sizes" ❖ When placing custom size originals: p.18 "Placing custom size originals" Note ❒ Do not stack originals above the limit mark on the side guide of the ADF. ❒ The last page should be on the bottom. ❒ When you copy 2-sided originals, both front and back sides of each original are scanned at once. ❒ Do not place objects on the sensors or cover them with your hands, or the original size may not be detected properly. Also, do not place anything on the exposure glass cover as this could cause a malfunction. 15