Toshiba Tecra A2-S239 Maintenance Manual - Page 243
Connector Board, Replacement Procedures
View all Toshiba Tecra A2-S239 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 243 highlights
4.13 Connector Board 4 Replacement Procedures 4.13 Connector Board This section describes how to remove and install a connector board with drawings of the board with parallel port (parallel port type) as an example. The procedure for a connector board with TV jack is the same. Removing the Connector Board The following describes the procedure for removing the Connector Board (See Figure 4-27, 4-28). 1. Remove the DC-IN jack from the slot of the base assembly. 2. Remove the following screws to remove the harness holder. • M2.5x4B THIN BIND screw x2 M2.5x4B THIN BIND DC-IN Jack Harness Holder Figure 4-27 Removing Harness Holder 3. Disconnect the USB I/F cable and connector board cable after unlock from the connector on the system board. 4. Remove the following screws to remove the connector board. • M2x2.8S THIN BIND screw x1 5. Remove the connector board by lifting it. Satellite A50/TECRA A2 Maintenance Manual (960-478) 4-39