Toshiba Tecra A2-S239 Maintenance Manual - Page 245
Fan, Removing the Fan, Installing the Fan
View all Toshiba Tecra A2-S239 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 245 highlights
4.14 Fan 4 Replacement Procedures 4.14 Fan Removing the Fan The follo wing describes the procedure for removing the fan (See Figure 4-29). 1. Disconnect the fan cable from the connector on the system board. 2. Remove the following screws and remove the fan module by raising it up. • M2.5x4B THIN BIND screw x2 M2.5x4B THIN BIND PJ8770 Fan Module Figure 4-29 Removing Fan Module Installing the Fan The following describes the procedure for installing the fan (See Figure 4-29). 1. Connect the fan cable to the connector PJ8770 on the system board. 2. Install the fan on the base assembly and secure it with the following screws. • M2.5x4B THIN BIND screw x2 Satellite A50/TECRA A2 Maintenance Manual (960-478) 4-41
4.14
Fan
4
Replacement Procedures
Satellite A50/TECRA A2
Maintenance Manual (960-478)
4-41
4.14 Fan
Removing the Fan
The follo wing describes the procedure for removing the fan (See Figure 4-29).
1.
Disconnect the
fan cable
from the connector on the system board.
2.
Remove the following
screws
and remove the
fan
module
by raising it up.
•
M2.5x4B THIN BIND screw
x2
Figure 4-29 Removing Fan Module
Installing the Fan
The following describes the procedure for installing the fan (See Figure 4-29).
1.
Connect the
fan cable
to the connector
PJ8770
on the system board.
2.
Install the
fan
on the base assembly and secure it with the following
screws
.
•
M2.5x4B THIN BIND screw
x2
Fan Module
M2.5x4B
THIN BIND
PJ8770