Toshiba Tecra A2-S239 Maintenance Manual - Page 80

2 Troubleshooting Procedures 2.4 System Board Troubleshooting D port status F107h F108h F109h F10Ah F10Bh F10Ch F10Dh Table 2-3 D port status (6/9) Inspection items Initializing PCI Initializing a LAN Serial interrupt control Initializing PnP hardware Configuration Initializing drives Checking the first 64KB of memory Initializing interrupt vectors Initializing a NDP Details Initializing PCI BUS (connecting DS Bus) Initializing information of LAN Checking the factor of WakeUp Running a task of waiting for the end of INIT_PCI Initializing the data in CMOS (2) Initializing PnP Setting up the setup parameters Waiting for the end of multiple box state check Setting up the hardware parameters based on resources Running a task of waiting for the end of PnP resource creation Serial interrupt control (performed before interrupt) Initializing PnP hardware Initializing PC Card Slots Initializing SIO (for models supporting SIO) Initializing FIR (for models supporting FIR) PCI automatic configuration Making of work for automatic configuration Acquisition of PCI IRQ PCI Configuration Storing of VGA configuration result Task generation for waiting PCI_CONFIGURATION completion Initialization of H/W which is necessary after PCI configuration Printer port setting (for models supporting PRT) HDD initialization sequence start FDD initialization sequence start (For models supporting built-in FDD) Enabling power off Output code generation Checking the first 64KB of memory Initializing interrupt vectors Initializing a NDP 2-26 Satellite A50/TECRA A2 Maintenance Manual (960-478)