Yamaha RX-V3900BL Owner's Manual - Page 136
Remote control, does not work or, function properly., SOURCE, does not learn new, functions.
UPC - 705105565903
View all Yamaha RX-V3900BL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 136 highlights
Troubleshooting ■ Remote control Problem The remote control does not work or function properly. The remote control does not learn new functions. Cause Remedy See page Wrong distance or angle. The remote control will function within a maximum 28 range of 6 m (20 ft) and no more than 30 degrees off- axis from the front panel. Direct sunlight or lighting (from an Reposition this unit. - inverter type of fluorescent lamp, etc.) is striking the remote control sensor of this unit. The batteries are weak. Replace all batteries. 4 The batteries do not last long and get Using alkaline batteries is strongly recommended. - quickly exhausted. Set the backlight mode to "OFF". 109 The operation mode selector is set incorrectly. Set the operation mode selector correctly. When - operating this unit, set it to the FAMP position. When operating the component selected by the input selector button, set it to the FSOURCE position. When operating the TV set in the 3TV area, set it to the FTV position. The control zone setting is incorrect. Select the zone you want to control. 119 The remote control code is not correctly Set the remote control code correctly using 109 set. "List of remote control codes" at the end of this manual. Try setting another code of the same manufacturer 109 using "List of remote control codes" at the end of this manual. The remote control ID of the remote control and this unit do not match. Match the remote control ID of this unit and the remote control. 116, 121 Even if the remote control code is Program the necessary functions independently into 111 correctly set, there are some models that the programmable buttons using the Learn feature. do not respond to the remote control. The batteries of this remote control and/or Replace the batteries. 4 the other remote control are too weak. The distance between the two remote Place the remote controls at the proper distance. 111 controls is too much or too little. The signal coding or modulation of the Learning is not possible. - other remote control is not compatible with this remote control. Memory capacity is full. Delete other unnecessary functions to make room for 115 the new functions. 132 En