ZyXEL P-660HW-T1 v2 User Guide - Page 98
No Security, WEP Encryption
View all ZyXEL P-660HW-T1 v2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 98 highlights
P-660HW-T v2 User's Guide 6.4.1 No Security Select No Security to allow wireless clients to communicate with the access points without any data encryption. Note: If you do not enable any wireless security on your ZyXEL Device, your network is accessible to any wireless networking device that is within range. Figure 49 Wireless: No Security The following table describes the labels in this screen. Table 28 Wireless No Security LABEL DESCRIPTION Security Mode Apply Cancel Advanced Setup Choose No Security from the drop-down list box. Click Apply to save your changes to the ZyXEL Device. Click Cancel to reload the previous configuration for this screen. Click Advanced Setup to display the Wireless Advanced Setup screen and edit more details of your WLAN setup. 6.4.2 WEP Encryption WEP encryption scrambles the data transmitted between the wireless clients and the access points to keep network communications private. It encrypts unicast and multicast communications in a network. Both the wireless clients and the access points must use the same WEP key. Your ZyXEL Device allows you to configure up to four 64-bit, 128-bit or 256-bit WEP keys but only one key can be enabled at any one time. In order to configure and enable WEP encryption; click Network > Wireless LAN to display the General screen. Select Static WEP from the Security Mode list. 98 Chapter 6 Wireless LAN