3Ware 9550SX-4LP User Guide - Page 244
Ch Source drive ECC error overwritten, 02Dh Source drive error occurred
UPC - 693494960044
View all 3Ware 9550SX-4LP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 244 highlights
Chapter 11. Troubleshooting 02Ch Source drive ECC error overwritten If a read error is encountered during a rebuild and the user chooses to ignore the error, the sector in error is reallocated. The user is notified of the event by this AEN. 02Dh Source drive error occurred If an error is encountered during a rebuild operation, this AEN is generated if the error was on a source drive of the rebuild. Knowing if the error occurred on the source or the destination of the rebuild is useful for troubleshooting. 02Eh Replacement drive capacity too small The 3ware RAID controller notifies the user by this AEN when the replacement drive capacity is smaller than required. The replacement drive must be equal to or greater capacity than the drive it's replacing. 02Fh Verify not started; unit never initialized This AEN will be sent by the controller when a verify operation is attempted but the unit has never been initialized before. The unit will transition to initializing mode. 030h Drive not supported 3ware 8000 and 9000 series Serial ATA Controller only support UltraDMA100/133 drives when using the parallel to serial ATA converter. This AEN indicates that an unsupported drive was detected during rollcall or a hot add. This AEN also could indicate that the Serial to Parallel converter was jumpered in the wrong place. The converter must be correctly jumpered to correspond to UDMA 100 or 133 drives. 032h Spare capacity too small for some units This AEN is sent by the controller when it finds a valid hot spare but the capacity is not sufficient to use it for a drive replacement. 033h Migration started This AEN is sent when migration of a unit is started. 234 3ware Serial ATA RAID Controller User Guide