3Ware 9550SX-4LP User Guide - Page 245

AEN Messages 034h Migration failed This AEN is sent when migration of a unit fails. Look at the Alarms page for other entries that will give you an idea of why the migration failed (such as a drive error on a specific port). 035h Migration completed This AEN is sent when migration of a unit is complete. The new capacity is now ready to be used. If the capacity of the array did not change, then you don't need to do anything else. If the capacity of the migrated array is larger, please refer to the part of this document on migration for information on how to change the file system to use the new capacity. 036h Verify fixed data/parity mismatch This AEN is sent by the controller when a verify error is found (parity inconsistency for RAID5/50 or data mismatch for RAID1/10 configuration) and recovered. If the error is not recovered the AEN_VERIFY_FAILED is returned instead. 037h SO-DIMM not compatible This AEN will be sent if an incompatible SODIMM memory has been connected to the controller. In this case, the controller is inoperable. 038h SO-DIMM not detected This AEN will be sent if there is no SODIMM memory connected to the controller. In this case, the controller is inoperable. 039h Buffer ECC error corrected This AEN will be sent when the controller has detected and corrected a memory ECC error. 03Ah Drive power on reset detected If the controller detects that a drive has been power-cycled, it will send this AEN. The controller may degrade the unit (if possible). 03Bh Rebuild paused This AEN will be sent when the rebuild operation is paused. Rebuilds are normally paused for ten minutes after a system first boots up and during non-scheduled times when scheduling is enabled. www.3ware.com 235