3Ware 9550SX-4LP User Guide - Page 246

Chapter 11. Troubleshooting 03Ch Initialize paused This AEN will be sent when the initialization is paused. Initializations are normally paused for ten minutes after a system first boots up and during non-scheduled times when scheduling is enabled. Initializations follow the rebuild schedule. 03Dh Verify paused This AEN will be sent when the verify operation is paused. Verifies are normally paused for ten minutes after a system first boots up and during non-scheduled times when scheduling is enabled. 03Eh Migration paused This AEN is sent when migration is paused. Migration follows the rebuild schedule. For more information, see "Scheduling Background Tasks" on page 184. 03Fh Flash file system error detected The 3ware RAID controller stores some configuration parameters as files in its flash memory. This AEN will be sent when a corrupted flash file system is found on the controller during boot-up. A further attempt will be made to repair the flash file system. These files usually get corrupted when a flash operation is interrupted by events such as power failures. 040h Flash file system repaired This AEN will be sent if a corrupted flash file system is successfully repaired. Some of the flash files with insufficient data may be lost in the operation. The configuration parameters which are lost will then return to their default values. 041h Unit number assignments lost The 3ware RAID controller tries to keep the unit numbers persistent across soft resets. This AEN will be sent if unit number assignments were lost from some unknown reasons.(This event rarely happens. Please contact AMCC 3ware technical support if this event occurs.) 042h Primary DCB read error occurred This AEN will be sent when the controller finds error in reading the primary copy of the Disk Configuration Block (DCB). The back-up copy of the DCB 236 3ware Serial ATA RAID Controller User Guide