Autodesk 235B1-05A761-1301 User Guide - Page 334

3 On the Properties palette on page 286, under General, click the part image. 4 In the Select a Part dialog, choose a part from the catalog. Select a Part dialog Under Select Part from Catalog, the dialog organizes pipe parts based on material type in the US Imperial and US Metric profiles. For more information, see Pipe Parts Catalog on page 262. 5 Select Display/Hide additional parameters to expand the contents of the parameters table. 6 Under Filter by Dimensions, filter the list of parts. NOTE The part catalogs and content locations determine the parts that you can add. 7 Select a part size and click OK. 8 In the drawing, move the cursor to the location on the pipe segment to add the takeoff. 9 Click the pipe curve connector. TIP For 1-line pipe, a pipe curve connector appears when you move the cursor over the pipe centerline. For 2-line pipe, a pipe curve connector appears when you move the cursor over the contour lines of the pipe. 10 (Optional) To change the insertion point after you place the takeoff, enter sl (slide), and specify a new insertion point. 11 Enter an angle to rotate the takeoff around the pipe, or use the compass to specify an angle. 12 Press Enter to end the command. TIP You can use rotate grips to rotate the newly added takeoff. 316 | Chapter 7 Drawing Piping Systems