Autodesk 235B1-05A761-1301 User Guide - Page 458

If you want to change... then... Note that the circuit length can only be calculated if the panel and all of the devices on the circuit are in the current drawing. the insertion point or normal. (The normal is the extrusion direction that is used when elevation is applied to the model view.) click Additional information. On the Location worksheet, enter the coordinates for the insertion point or normal, and click OK. NOTE You can also use Alignment grips to move the panel. 5 If necessary, expand Advanced, expand System, and for System, select a new system. 6 Expand Design Data, and modify the design data properties as needed: If you want to change... then... the panel name for Name, enter a unique name. the panel rating for Rating, enter a new rating. the number of slots for Slots, enter a new number. NOTE Do not assign more circuits to a panel than allowed for by the number of slots. If a panel has more circuits than slots, some of the circuits cannot be included in the panel schedule. When you create a schedule, the software warns you if this situation exists. the voltage the phase for Voltage, enter a new voltage. for Phases, select 1 or 3. NOTE The rating and voltage of a panel do not affect how the software functions. However, they are made available as automatic properties. 7 Press Esc. NOTE Anytime you modify panels, you will need to update any existing panel schedules. See Updating Panel Schedules on page 459 If you are using this drawing as an electrical project database, and you modify properties for a panel whose circuits are used in linked drawings, you are prompted to open and save the affected drawings when you save the electrical project database. Modifying Wires After drawing or generating wires, you might need to make changes to the layout or to the wire properties. 440 | Chapter 9 Drawing Electrical Systems