Autodesk 235B1-05A761-1301 User Guide - Page 556

If you want to modify... then... the location (for end-of-line symbols only) click Additional information, enter new coordinates for the insertion point on the Location worksheet, and click OK. NOTE You can also move both end-of-line symbols and inline symbols using Location grips. For more information, see Moving Schematic Symbols on page 540. the ID 4 Press ESC. expand Advanced, expand Design Data, and for ID, revise the value for ID. Moving Schematic Lines You can move a schematic line by ■ Selecting a grip and dragging it to a new location ■ Using the AutoCAD® MOVE command ■ Entering new coordinate values for the insertion point of the line using the Properties palette. You can also use the palette to change the normal or the angle of rotation, as described later in this section. When you move a schematic line, in-line schematic symbols that are anchored to the line are moved along the line. To move a schematic line in orthographic mode using grips 1 Select the line. 2 Click the Location grip . 3 Move the line: If you want to... then... use the grip point as the base point for the move drag the line to a new location, and click. specify a base point, and then specify a second point enter b (base point), specify the base point, and then specify the second point. If the schematic line segment is not connected to another object, you can change both its length and angle using the Start grip or End grip. The Start grip and End grip only appear on the schematic line in orthographic mode. The Start and End grips enable you to change the XYZ location of the start point or end point of the segment. This is useful when you are initially designing runs because you can easily connect a segment to an existing run. 538 | Chapter 11 Drawing Schematic Diagrams