Autodesk 235B1-05A761-1301 User Guide - Page 415

5 For Circuit, select the circuit. Specify the connector properties 6 Under Value, specify values for the connector properties. Connector Property Description System The system of the connector. If the system type of the connector is General, you can select from all of the electrical systems defined in the drawing. Otherwise, you can select from systems with the same system type (Power and Lighting, or Other). NOTE While the system assigned to the device determines its display properties, the system assigned to the connector on a device determines the connections that can be made to the connector. If the system type of the connector's system is Power and Lighting or Other, you can only connect objects of the same system type to the connector. If the system type is General, you can connect objects of any system type to the connector. Load Phase 1 Load Phase 2 Load Phase 3 Voltage Number of poles The load on the connector. Applies only to connectors whose system type is Power and Lighting. If the Number of Poles is or 1, only Load Phase 1 is editable. If Number of Poles is 2, then Load Phase 1 and Load Phase 2 are editable. If Number of Poles is 3 or , then Load Phase 1, Load Phase 2, and Load Phase 3 are editable. You can enter a value. Otherwise, the value in the style is used and shown. The voltage on the connector. Applies only to connectors whose system type is Power and Lighting. You can do one of the following: ■ enter a voltage ■ select from the voltages defined in the drawing that are valid for the currently specified number of poles ■ select By Circuit to retrieve the value from the circuit when it is assigned The number of poles on the connector: 1, 2, or 3. Applies only to connectors whose system type is Power and Lighting. You can select a number, or you can select By Circuit to retrieve the value from the circuit when it is assigned. Adding Devices | 397