Cisco 7962G Administration Guide - Page 130

Status Menu Chapter 7 Viewing Model Information, Status, and Statistics on the Cisco Unified IP Phone Table 7-3 Network Statistics Message Information (continued) Item One of the following values: Initialized TCP-timeout CM-closed-TCP TCP-Bad-ACK CM-reset-TCP CM-aborted-TCP CM-NAKed KeepaliveTO Failback Phone-Keypad Phone-Re-IP Reset-Reset Reset-Restart Phone-Reg-Rej Load Rejected HC CM-ICMP-Unreach Phone-Abort Elapsed Time Port 1 Port 2 DHCP BOUND Description Cause of the last reset of the phone Amount of time that has elapsed since the phone last rebooted Link state and connection of the PC port (for example, Auto 100 Mb Full-Duplex means that the PC port is in a link-up state and has auto-negotiated a full-duplex, 100-Mbps connection) Link state and connection of the Network port Phone is bound to the DHCP server, DHCP parameters are acceptable, and the phone has received a DHCPACK message. Firmware Versions Screen The Firmware Versions screen displays information about the firmware version that is running on the phone. Table 7-4 describes the information that is displayed on this screen. To display the Firmware Version screen, follow these steps: Procedure Step 1 Step 2 Step 3 Press the Settings button. Select Status. Select Firmware Versions. To exit the Firmware Version screen, press the Exit softkey. 7-10 Cisco Unified IP Phone 7962G and 7942G Administration Guide for Cisco Unified Communications Manager 6.1 OL-14625-01