Cisco NM-8B-U User Guide - Page 132
Interface Speed Example, Setting the Interface Duplex Mode Example
UPC - 074632001001
View all Cisco NM-8B-U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 132 highlights
16- and 36-Port Ethernet Switch Module for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Configuration Examples for the 16- and 36-Port Ethernet Switch Module Interface Speed Example The following example shows the interface speed being set to 100 Mbps on the Fast Ethernet interface 5/4: Router(config)# interface fastethernet 5/4 Router(config-if)# speed 100 Setting the Interface Duplex Mode Example The following example shows the interface duplex mode being set to full on Fast Ethernet interface 5/4: Router(config)# interface fastethernet 5/4 Router(config-if)# duplex full Adding a Description for an Interface Example The following example shows how to add a description on Fast Ethernet interface 5/5: Router(config)# interface fastethernet 5/5 Router(config-if)# description Channel-group to "Marketing" Configuring an Ethernet Interface as a Layer 2 Trunk Example The following example shows how to configure the Fast Ethernet interface 5/8 as an 802.1Q trunk. This example assumes that the neighbor interface is configured to support 802.1Q trunking: Router# configure terminal Enter configuration commands, one per line. End with CNTL/Z. Router(config)# interface fastethernet 5/8 Router(config-if)# shutdown Router(config-if)# switchport trunk encapsulation dot1q Router(config-if)# switchport mode trunk Router(config-if)# no shutdown Router(config-if)# end Router# exit VLAN Configuration Example The following example shows how to configure the VLAN: Router# vlan database Router(vlan)# vlan 3 VLAN 3 added: Name: VLAN0003 Router(vlan)# exit APPLY completed. Exiting.... 132 Cisco IOS Release 12.2(2)XT, 12.2(8)T, and 12.2(15)ZJ