Cisco NM-8B-U User Guide - Page 153
Configuring Layer 3 Interfaces Example, show running-config, show interfaces
UPC - 074632001001
View all Cisco NM-8B-U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 153 highlights
16- and 36-Port Ethernet Switch Module for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Configuration Examples for the 16- and 36-Port Ethernet Switch Module RTP/IP header compression is disabled Probe proxy name replies are disabled Policy routing is disabled Network address translation is disabled WCCP Redirect outbound is disabled WCCP Redirect exclude is disabled BGP Policy Mapping is disabled The following is sample output for the show running-config privileged EXEC command for Gigabit Ethernet interface 0/2: Switch# show running-config interface gigabitethernet0/2 Building configuration... Current configuration : 122 bytes ! interface GigabitEthernet0/2 no switchport ip address 192.20.135.21 255.255.255.0 speed 100 mls qos trust dscp end Configuring Layer 3 Interfaces Example The following example shows how to configure Gigabit Ethernet interface 0/10 as a routed port and to assign it an IP address: Switch# configure terminal Enter configuration commands, one per line. End with CNTL/Z. Switch(config)# interface gigabitethernet0/10 Switch(config-if)# no switchport Switch(config-if)# ip address 10.1.2.3 255.255.0.0 Switch(config-if)# no shutdown Switch(config-if)# end The following is sample output from the show interfaces privileged EXEC command for Gigabit Ethernet interface 0/2: Switch(config)# show interfaces gigabitethernet0/2 GigabitEthernet0/2 is up, line protocol is up Hardware is Gigabit Ethernet, address is 0002.4b29.4400 (bia 0002.4b29.4400) Internet address is 192.20.135.21/24 MTU 1500 bytes, BW 100000 Kbit, DLY 10 usec, reliability 255/255, txload 1/255, rxload 1/255 Encapsulation ARPA, loopback not set Keepalive set (10 sec) Full-duplex, 100Mb/s input flow-control is off, output flow-control is off ARP type: ARPA, ARP Timeout 04:00:00 Last input 00:00:02, output 00:00:08, output hang never Last clearing of "show interface" counters never Queueing strategy: fifo Output queue 0/40, 0 drops; input queue 0/75, 0 drops 5 minute input rate 0 bits/sec, 0 packets/sec 5 minute output rate 0 bits/sec, 0 packets/sec 89604 packets input, 8480109 bytes, 0 no buffer Received 81848 broadcasts, 0 runts, 0 giants, 0 throttles 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored 0 input packets with dribble condition detected 60665 packets output, 6029820 bytes, 0 underruns 0 output errors, 0 collisions, 16 interface resets Cisco IOS Release 12.2(2)XT, 12.2(8)T, and 12.2(15)ZJ 153