Cisco NM-8B-U User Guide - Page 57
Verifying Layer 2 EtherChannels
UPC - 074632001001
View all Cisco NM-8B-U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
16- and 36-Port Ethernet Switch Module for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Configuration Tasks Verifying Layer 2 EtherChannels Use the following show commands to verify Layer 2 EtherChannels: Step 1 Router# show running-config interface fastethernet 5/6 Building configuration... Current configuration: ! interface FastEthernet5/6 no ip address switchport switchport access vlan 10 switchport mode access channel-group 2 mode on end Step 2 Router# show interfaces fastethernet 5/6 etherchannel Port state = EC-Enbld Up In-Bndl Usr-Config Channel group = 2 Mode = Desirable Port-channel = Po2 GC = 0x00020001 Port indx = 1 Load = 0x55 Gcchange = 0 Flags: S - Device is sending Slow hello. C - Device is in Consistent state. A - Device is in Auto mode. P - Device learns on physical port. Timers: H - Hello timer is running. Q - Quit timer is running. S - Switching timer is running. I - Interface timer is running. Local information: Hello Partner PAgP Learning Group Port Flags State Timers Interval Count Priority Method Ifindex Fa5/6 SC U6/S7 30s 1 128 Any 56 Partner's information: Port Fa5/6 Partner Name JAB031301 Partner Device ID 0050.0f10.230c Partner Port 2/47 Partner Group Age Flags Cap. 18s SAC 2F Age of the port in the current state: 00h:10m:57s Step 3 Router# show running-config interface port-channel 2 Building configuration... Current configuration: ! interface Port-channel2 no ip address switchport switchport access vlan 10 switchport mode access end Router# Cisco IOS Release 12.2(2)XT, 12.2(8)T, and 12.2(15)ZJ 57