Cisco NM-8B-U User Guide - Page 60

Configuration Tasks 16- and 36-Port Ethernet Switch Module for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series • Setting the Switch-to-Client Frame-Retransmission Number, page 65 • Enabling Multiple Hosts, page 66 Understanding the Default 802.1x Configuration Table 10 shows the default 802.1x configuration. Table 10 Default 802.1x Configuration Feature Authentication, authorization, and accounting (AAA) RADIUS server • IP address • UDP authentication port • Key Per-interface 802.1x enable state Periodic reauthentication Number of seconds between reauthentication attempts Quiet period Retransmission time Maximum retransmission number Multiple host support Client timeout period Authentication server timeout period Default Setting Disabled. • None specified. • 1645. • None specified. Disabled (force-authorized). The port transmits and receives normal traffic without 802.1x-based authentication of the client. Disabled. 3600 seconds. 60 seconds (number of seconds that the switch remains in the quiet state following a failed authentication exchange with the client). 30 seconds (number of seconds that the switch should wait for a response to an EAP request/identity frame from the client before retransmitting the request). 2 times (number of times that the switch will send an EAP-request/identity frame before restarting the authentication process). Disabled. 30 seconds (when relaying a request from the authentication server to the client, the amount of time the switch waits for a response before retransmitting the request to the client). This setting is not configurable. 30 seconds (when relaying a response from the client to the authentication server, the amount of time the switch waits for a reply before retransmitting the response to the server). This setting is not configurable. Cisco IOS Release 12.2(2)XT, 12.2(8)T, and 12.2(15)ZJ 60