Dell PowerEdge M420 Hardware Owner's Manual - Page 103

Table 1-25. LCD Status Messages (continued) Code Text Cause Corrective Actions E2111 SBE log disabled on DIMM ##. Reseat DIMM. The system BIOS has Remove AC power to the disabled memory single-bit system for 10 seconds and error (SBE) logging and restart the system. does not log anymore SBEs until the system is rebooted. "##" represents the DIMM implicated by the BIOS. If the problem persists, see "Troubleshooting Blade Memory" on page 297. E2112 Memory spared on DIMM ##. Power cycle AC. The system BIOS has Remove AC power to the spared the memory because system for 10 seconds and it has determined the restart the system. memory had too many errors. "##" represents the DIMM implicated by the BIOS. If the problem persists, see "Troubleshooting Blade Memory" on page 297. E2113 Mem mirror OFF on DIMM ## & ##. Power cycle AC The system BIOS has Remove AC power to the disabled memory mirroring system for 10 seconds and because it has determined restart the system. that half of the mirror has had too many errors. "## & ##" represents the DIMM pair implicated by the BIOS. If the problem persists, see "Troubleshooting Blade Memory" on page 297. I1911 LCD Log Full. Check SEL to review all Errors. LCD overflow message. A maximum of ten error messages can display sequentially on the LCD. The eleventh message instructs the user to check the SEL for details on the events. Check the SEL for details on the events. Remove AC power to the system for 10 seconds or clear the SEL. I1912 SEL full. Review & clear log. The SEL is full of events and is unable to log any more. Check the SEL for details of the error messages, then remove AC power to the system for 10 seconds to clear the SEL and restart the system. About Your System 103