Dell PowerEdge M420 Hardware Owner's Manual - Page 122

Table 1-26. Blade Messages (continued) Message Causes Corrective Actions TPM configuration operation is pending. Press (I) to Ignore OR (M) to Modify to allow this change and reset the system. This message is displayed Enter I or M to proceed. when the system re-starts after a TPM configuration command is entered. WARNING: Modifying could prevent security TPM configuration operation honored. System will now reset TPM configuration operation command has been accepted For information only. Unsupported CPU combination. Mismatched processors are Replace a processor so that installed. both processors match. See Processor is not supported "Processors" on page 225. by the blade. Check for a BIOS update using the Dell Support website at support.dell.com. Unsupported CPU Processor is not supported Check for a BIOS update stepping detected. by the blade. using the Dell Support website at support.dell.com. If the problem persists, install a supported processor. See "Processors" on page 225. CPU set to minimum The processor speed may If not an intentional setting, frequency. be intentionally set low for check any other system power conservation. messages for possible causes. 122 About Your System