Dell PowerEdge M420 Hardware Owner's Manual - Page 225
Installing the Expansion-Card Riser, Processors, Processor Installation Guidelines
View all Dell PowerEdge M420 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 225 highlights
Installing the Expansion-Card Riser 1 Align the riser guides on each end of the expansion-card riser with the riser guide posts on the system board and lower the riser into the blade until the riser is fully seated on the system board. See Figure 3-38. 2 If applicable, reinstall the expansion card(s). See "Installing an Expansion Card" on page 218. 3 Connect the power and data cables to the riser connectors. See Figure 3-36 and Figure 3-37. 4 Slide the impedance wall into the slots on the expansion-card riser and the chassis inner wall. See Figure 3-35. 5 Close the blade. See "Closing the Blade" on page 159. Processors Processor Installation Guidelines PowerEdge M910 System • The PowerEdge M910 system supports two or four eight core Intel® Xeon® 7xxx series processors only. • Single-processor configuration is not supported. PowerEdge M905 System • The PowerEdge M905 system supports dual-core or quad-core AMD™ Opteron™ 8xxxx series processors only. • Four processors must be installed; dual-processor configurations are not supported. • Only AMD 8xxxx MP series processors are supported. Installing Blade Components 225