Dell PowerEdge M420 Hardware Owner's Manual - Page 119

Table 1-26. Blade Messages (continued) Message Causes Corrective Actions PCI BIOS failed to install. Faulty or improperly installed mezzanine card. Reseat the mezzanine card. See "I/O Module Mezzanine Cards" on page 198. If the problem persists, see "Getting Help" on page 337. Plug & Play Configuration Error. Error encountered in initializing PCI device; faulty blade board. Set the NVRAM_CLR jumper to "on" and reboot the blade. See "Blade System Board Jumper Settings" on page 309 for the jumper location. Check for a BIOS update. If the problem persists, see "Getting Help" on page 337. PCIe Training Error: Expected Link Width is x', Actual Link Width is x Faulty or improperly installed PCIe card in the specified slot. Reseat the PCIe card in the specified slot number. See "Troubleshooting Expansion Cards" on page 299. If the problem persists, see "Getting Help" on page 337. ROM bad checksum = address Expansion card improperly Ensure that the expansion installed or faulty. card is installed properly. See "Troubleshooting Expansion Cards" on page 299. BIOS Update Attempt Failed. BIOS remote update failed. Retry the BIOS update. If problem persists, see "Getting Help" on page 337. Invalid configuration information please run SETUP program CMOS checksum failure. Run the System Setup program and review the current settings. See "Using the System Setup Program and UEFI Boot Manager" on page 127. About Your System 119