Dell PowerEdge M420 Hardware Owner's Manual - Page 214
iDRAC6 Enterprise Card, Installing an iDRAC6 Enterprise Card
View all Dell PowerEdge M420 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 214 highlights
To boot from the USB memory key, you must configure the USB memory key with a boot image, and then specify the USB memory key in the boot sequence in the System Setup program. See "Boot Settings Screen" on page 133. For information on creating a bootable file on the USB memory key, see the user documentation that accompanied the USB memory key. CAUTION: To avoid interference with other components in the blade, the maximum allowable dimensions of the USB key are 15.9 mm wide x 57.15 mm long x 7.9 mm high. Figure 3-32. Installing a USB Memory Key 2 1 1 USB memory key connector on system board (M710/M910) or backplane (M710HD, M610, and M610x) 2 USB memory key iDRAC6 Enterprise Card Installing an iDRAC6 Enterprise Card 1 Remove the blade. See "Removing a Blade" on page 145. 2 Open the blade. See "Opening the Blade" on page 149. 3 Install the iDRAC6 Enterprise card: a Lower the card into place until the card connector fits into the corresponding connector on the system board. See Figure 3-33. b Secure the card with the two Torx screws. 214 Installing Blade Components