Dell PowerEdge M420 Hardware Owner's Manual - Page 115

Table 1-26. Blade Messages (continued) Message Causes Corrective Actions Error: Incorrect memory configuration. DIMMs must be installed in pairs of matched memory size, speed, and technology. Mismatched or Ensure that all pairs of unmatched DIMMs memory modules are of the installed; faulty or same type and size, and that improperly seated memory they are properly installed. modules. See "System Memory" on page 159 If the problem persists, see "Troubleshooting Blade Memory" on page 297. Error: Incorrect memory configuration. System halted. Less than 512 MB of memory installed. Add memory modules to achieve a configuration supported by the system. See "System Memory" on page 159. Error: Memory failure detected. Memory size reduced. Replace the faulty DIMM as soon as possible. Faulty or improperly seated memory modules. See "Troubleshooting Blade Memory" on page 297. Error programming flexAddress (MAC) for bus, device, function. FlexAddress (virtual Information only. MAC) is not supported on the specified device. Error programming flexAddress (iSCSI MAC) for bus, device, function. FlexAddress (virtual Information only. MAC) is not supported on the specified device. Error resetting NIC after programming flexAddress for bus, device, function. FlexAddress (virtual Information only. MAC) is not supported on the specified device. About Your System 115