Dell PowerEdge M420 Hardware Owner's Manual - Page 217
Installing the LOM Riser Card, Expansion Cards and Expansion-Card Riser (PowerEdge M610x Only)
View all Dell PowerEdge M420 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 217 highlights
Installing the LOM Riser Card 1 Remove the blade. See "Removing a Blade" on page 145. 2 Open the blade. See "Opening the Blade" on page 149. 3 Install the Network Daughter Card: a Lower the card into place until the card connector fits into the corresponding connector on the system board. See Figure 3-34. b Secure the card with the three screws. 4 Tighten the screws to secure the card to the system board. See Figure 3-34. 5 Close the blade. See "Closing the Blade" on page 159. 6 Install the blade. See "Installing a Blade" on page 148. Expansion Cards and Expansion-Card Riser (PowerEdge M610x Only) Expansion Card Installation Guidelines Your system supports up to two Generation 2 PCIe expansion cards installed in the connectors on the expansion-card riser. To locate the expansion-card connectors on the expansion-card riser, see Figure 3-38. • The expansion slots support full-height, full-length, single- or double- width cards. • Each expansion card can have a power consumption of up to 250 W. NOTE: If only a single PCIe expansion card is installed, it can have power consumption up to 300 W. • Both the expansion slots are x16 connectors. • Do not install an expansion card in slot 2 if a double-width card is installed in slot 1. Installing Blade Components 217