Dell PowerEdge MX740c EMC PowerEdge MX740c Installation and Service Manual - Page 108
Removing the system battery, Installing the system battery
![]() |
View all Dell PowerEdge MX740c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 108 highlights
Figure 80. Removing the system battery 3. To install a new system battery: a. Hold the battery with the + sign facing the positive side of the battery connector. b. Insert the battery down into the connector and push the positive side of the battery until the battery snaps into place. Figure 81. Installing the system battery Next steps 1. Follow the procedure listed in After working inside your sled on page 42. 2. Enter the System Setup to confirm that the battery is operating properly. 3. Enter the correct time and date in the System Setup's Time and Date fields. 4. Exit the System Setup. 5. To test the newly installed battery, remove the system from the enclosure, for at least an hour. 6. Reinstall the system into the enclosure, after an hour. 7. Enter the System Setup and if the time and date are still incorrect, see Getting help. 108 Installing and removing system components
![](/manual_guide/products/dell-poweredge-mx7000-emc-poweredge-mx740c-installation-service-manual-49e067c/108.png)