Dell PowerEdge MX740c EMC PowerEdge MX740c Installation and Service Manual - Page 25
SATA Settings details, NVMe Settings
View all Dell PowerEdge MX740c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
2. Press F2 immediately after you see the following message: F2 = System Setup NOTE: If your operating system begins to load before you press F2, wait for the system to finish booting, and then restart your system and try again. 3. On the System Setup Main Menu screen, click System BIOS. 4. On the System BIOS screen, click SATA Settings. SATA Settings details About this task The SATA Settings screen details are explained as follows: Option Description Embedded SATA Security Freeze Lock Write Cache Port n Enables the embedded SATA option to be set to Off , AHCI, or RAID modes. This option is set to AHCI Mode by default. Sends Security Freeze Lock command to the embedded SATA drives during POST. This option is applicable only for AHCI mode. This option is set to Enabled by default. Enables or disables the command for the embedded SATA drives during POST. This option is set to Disabled by default. Sets the drive type of the selected device. For AHCI Mode or RAID Mode, BIOS support is always enabled. Option Description Model Specifies the drive model of the selected device. NOTE: If no device is installed, it displays Unkown. Drive Type Specifies the type of drive attached to the SATA port. NOTE: If no device is installed, it displays Unkown Device. Capacity Specifies the total capacity of the drive. This field is undefined for removable media devices such as optical drives. NOTE: If no device is installed, it displays N/A. NVMe Settings The NVMe settings enable you to set the NVMe drives to either RAID mode or Non-RAID mode. NOTE: To configure these drives as RAID drives, click System BIOS Settings > SATA Settings > Embedded SATA Option and enable RAID mode. If not, you must set this field to Non-RAID mode. View NVMe settings To view the NVMe Settings screen, perform the following steps: Steps 1. Turn on, or restart your system. 2. Press F2 immediately after you see the following message: F2 = System Setup Pre-operating system management applications 25