Dell PowerEdge MX740c EMC PowerEdge MX740c Installation and Service Manual - Page 68
Control panel, Removing the control panel
View all Dell PowerEdge MX740c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
Figure 45. Installing the BBU into the BBU cage Next steps 1. Install the BBU module. Control panel The control panel allows you to manually control the inputs to the sled. Removing the control panel Prerequisites 1. Follow the safety guidelines listed in Safety Instructions. 2. Follow the procedure listed in Before working inside the sled. 3. Remove the drives. 4. Remove the drive cage. Steps 1. Pull the blue strap to disconnect the control panel cable connected to the system board. 2. Using a Phillips #1 screwdriver, remove the screws that secure the control panel to the system. 3. Slide the control panel out of the system. 68 Installing and removing system components
Figure 45. Installing the BBU into the BBU cage
Next steps
1.
Install the BBU module
.
Control panel
The control panel allows you to manually control the inputs to the sled.
Removing the control panel
Prerequisites
1.
Follow the safety guidelines listed in
Safety Instructions
.
2.
Follow the procedure listed in
Before working inside the sled
.
3.
Remove the drives
.
4.
Remove the drive cage
.
Steps
1.
Pull the blue strap to disconnect the control panel cable connected to the system board.
2.
Using a Phillips #1 screwdriver, remove the screws that secure the control panel to the system.
3.
Slide the control panel out of the system.
68
Installing and removing system components