Dell PowerEdge MX740c EMC PowerEdge MX740c Installation and Service Manual - Page 99
Removing the M.2 BOSS card
View all Dell PowerEdge MX740c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 99 highlights
Figure 71. Installing the M.2 boss module Next steps Follow the procedure listed in After working inside your sled. Removing the M.2 BOSS card Prerequisites 1. Follow the safety guidelines listed in the Safety instructions. 2. Follow the procedure listed in the Before working inside your sled on page 42. 3. Remove the M.2 BOSS card. Steps 1. Using the Phillips #1 screwdriver, remove the screw on the M.2 BOSS module. 2. Pull the card out of the connector, and lift the card away from the module. Installing and removing system components 99
Figure 71. Installing the M.2 boss module
Next steps
Follow the procedure listed in
After working inside your sled
.
Removing the M.2 BOSS card
Prerequisites
1.
Follow the safety guidelines listed in the
Safety instructions
.
2.
Follow the procedure listed in the
Before working inside your sled
on page 42.
3.
Remove the M.2 BOSS card
.
Steps
1.
Using the Phillips #1 screwdriver, remove the screw on the M.2 BOSS module.
2.
Pull the card out of the connector, and lift the card away from the module.
Installing and removing system components
99