Dell PowerEdge R760XA Installation and Service Manual - Page 128
Removing the GPU riser module
![]() |
View all Dell PowerEdge R760XA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 128 highlights
Figure 93. Installing an expansion card into the expansion card riser Next steps 1. If applicable, connect the cables to the expansion card. 2. Install the expansion card riser. 3. Install the air shroud. 4. Follow the procedure listed in After working inside your system. 5. Install any device drivers required for the card as described in the documentation for the card. Removing the GPU riser module The procedure to remove left and right GPU riser module are similar. Prerequisites 1. Follow the safety guidelines listed in the Safety instructions. 2. Follow the procedure listed in the Before working inside your system. 3. Disconnect the GPU power, signal cables, and BP/PERC cables from the system board. 4. Remove the air shroud. 5. Remove the cooling fan cage assembly. 6. Disconnect the riser board cables from the system board. 7. If installed, remove the sponges. Steps 1. Press the blue button on the GPU riser module, lift handle comes out of GPU riser module. 128 Installing and removing system components
![](/manual_guide/products/dell-poweredge-r760xa-installation-service-manual-7a27fb2/128.png)