Dell PowerEdge R760XA Installation and Service Manual - Page 130
Installing the GPU riser module
View all Dell PowerEdge R760XA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 130 highlights
Installing the GPU riser module The procedure to install left and right GPU riser module are similar. Prerequisites 1. Follow the safety guidelines listed in the Safety instructions. 2. Follow the procedure listed in Before working inside your system. 3. Remove the air shroud. 4. Remove the cooling fan cage assembly. 5. Disconnect the GPU power and signal cables from the system board. 6. Remove the rear mounting front PERC module. 7. If installed, remove the sponges. Steps 1. Use both hands to hold the GPU riser module, align the holes on the GPU riser module with the guides on the system side wall and base. 2. Lower the GPU riser module into system and press the touch points until the GPU riser module is firmly seated into the system. 3. Rotate to close the GPU lift handle into the GPU riser module. Figure 96. Installing the right GPU riser module 130 Installing and removing system components