Dell PowerEdge R760XA Installation and Service Manual - Page 183
Install the M.2 SSD. To install the M.2 SSD, see, Remove the M.2 SSD. To remove the M.2 SSD
View all Dell PowerEdge R760XA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 183 highlights
Figure 155. Installing the BOSS-N1 module blank To install the BOSS-N1 module: 1. Install the BOSS-N1 module. To install the BOSS-N1 , see installing the BOSS-N1 module steps 1 to 5. 2. Install the M.2 SSD. To install the M.2 SSD, see installing the BOSS-N1 module steps 6 to 10. NOTE: Installing the BOSS-N1 card carrier does not require the system to be powered off. System shutdown is only required when installing the BOSS-N1 module. To remove the BOSS-N1 module: 1. Power off the system and remove the system cover. 2. Remove the M.2 SSD. To remove the M.2 SSD, see removing the BOSS-N1 module steps 1 to 4. 3. Remove the BOSS-N1 module. To remove the BOSS-N1 module, see removing the BOSS-N1 module steps 5 to 8. 4. Install the BOSS blank. NOTE: Removal of the BOSS-N1 card carrier does not require the system to be powered off. System shutdown is only required when removing the BOSS-N1 module. NOTE: Disconnect the BOSS signal cable and the BOSS power cable before lifting the controller card module from the system. Upgrade Kits 183