Dell PowerEdge R760XA Installation and Service Manual - Page 152
Installing the BOSS-N1 module
View all Dell PowerEdge R760XA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 152 highlights
Next steps 1. Replace the BOSS-N1 module or Install the BOSS-N1 card blank. Installing the BOSS-N1 module Prerequisites 1. Follow the safety guidelines listed in the Safety instructions. 2. Follow the procedure listed in the Before working inside your system. Steps 1. Connect the BOSS-N1 power and signal cables to the connectors on the BOSS-N1 module. Figure 122. Connecting the BOSS-N1 power and signal cables to the BOSS-N1 module 2. Align the BOSS-N1 module at an angle with the controller card module slot. 3. Insert the BOSS-N1 module and push the module horizontally towards the rear of the system until firmly seated. 4. Using the Phillips #1 screwdriver, secure the BOSS-N1 module with the M3 x 0.5 x 4.5 mm screw. 5. Connect the BOSS-N1 power and signal cable to the connectors on the system board. 152 Installing and removing system components