Dell PowerEdge R760XA Installation and Service Manual - Page 133
Installing the GPU, Installing the GPU blank
View all Dell PowerEdge R760XA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 133 highlights
Figure 99. Installing the GPU blank Next steps 1. Replace the GPU. Installing the GPU Prerequisites 1. Follow the safety guidelines listed in the Safety instructions. 2. Follow the procedure listed in Before working inside your system. 3. If installed, remove the sponges. 4. Remove the GPU riser module. 5. If installed, remove the bridge cards. 6. If installing a new GPU card, unpack it and prepare the card for installation. NOTE: For instructions, see the documentation accompanying the card. CAUTION: Do not install GPUs, network cards, or other PCIe devices on your system that are not validated and tested by Dell. Damage caused by unauthorized and invalidated hardware installation will null and void the system warranty. Steps 1. If installed, remove the GPU blank: a. Open the GPU card holder latches on both ends of the riser. b. Pull hockey stick by the pull tape. c. Hold the GPU blank by the edges and pull the card from the riser. NOTE: Store the GPU blank for future use. GPU blank must be installed in empty expansion card slots to maintain Federal Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system. Installing and removing system components 133