Dell PowerEdge R760XA Installation and Service Manual - Page 150
Removing the BOSS-N1 card carrier, Removing the M.2 SSD
View all Dell PowerEdge R760XA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 150 highlights
Figure 118. Removing the BOSS-N1 card carrier 3. Using the Phillips #1 screwdriver remove the M3 x 0.5 x 4.5 mm screw that secures the M.2 SSD to the BOSS-N1 card carrier. 4. Slide the M.2 SSD out from the BOSS-N1 card carrier. Figure 119. Removing the M.2 SSD 5. Disconnect the BOSS-N1 power and signal cable from the system board. WARNING: Ensure to disconnect the BOSS-N1 power cable before removing the Riser 1. 6. Using the Phillips #1 screwdriver remove the M3 x 0.5 x 4.5 mm screw that secures the BOSS-N1 module on Riser 1. 7. Slide the BOSS-N1 module towards the front of the chassis and lift the module. 150 Installing and removing system components
Figure 118. Removing the BOSS-N1 card carrier
3.
Using the Phillips #1 screwdriver remove the M3 x 0.5 x 4.5 mm screw that secures the M.2 SSD to the BOSS-N1 card
carrier.
4.
Slide the M.2 SSD out from the BOSS-N1 card carrier.
Figure 119. Removing the M.2 SSD
5.
Disconnect the BOSS-N1 power and signal cable from the system board.
WARNING:
Ensure to disconnect the BOSS-N1 power cable before removing the Riser 1.
6.
Using the Phillips #1 screwdriver remove the M3 x 0.5 x 4.5 mm screw that secures the BOSS-N1 module on Riser 1.
7.
Slide the BOSS-N1 module towards the front of the chassis and lift the module.
150
Installing and removing system components