Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.1.0 - Page 129
Fibre Channel zoning, Oper-State DOWN
View all Dell PowerSwitch S4128F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 129 highlights
FCF Priority 128 FKA-Adv-Period Enabled,8 Config-State ACTIVE Oper-State DOWN Members OS10# show running-configuration vfabric ! vfabric 10 name 10 vlan 100 fcoe fcmap 0xEFC01 fcoe fcf-priority 128 fcoe fka-adv-period 8 fcoe vlan-priority 3 Fibre Channel zoning Fibre Channel (FC) zoning partitions a FC fabric into subsets to restrict unnecessary interactions, improve security, and manage the fabric more effectively. Create zones and add members to the zone. Identify a member by an FC alias, World Wide Name (WWN), or FC ID. A zone can have a maximum of 255 unique members. Create zonesets and add the zones to a zoneset. A switch can have multiple zonesets, but you can activate only one zoneset at a time in a fabric. 1 (Optional) Create an FC alias using the fc alias alias-name command in CONFIGURATION mode. The switch enters Alias CONFIGURATION mode. 2 Add members to the alias using the member {wwn wwn-ID | fc-id fc-id} command in Alias CONFIGURATION mode. You can add a maximum of 255 unique members. 3 Create a zone using the fc zone zone-name command in the CONFIGURATION mode. The switch enters Zone CONFIGURATION mode. 4 Add members to the zone with the member {alias-name alias-name | wwn wwn-ID | fc-id fc-id} command in Zone CONFIGURATION mode. 5 Create a zoneset using the fc zoneset zoneset-name command in CONFIGURATION mode. The switch enters Zoneset CONFIGURATION mode. 6 Add the existing zones to the zoneset with the member zone-name command in Zoneset CONFIGURATION mode. 7 Activate the zoneset using the zoneset activate zoneset-name command in vfabric CONFIGURATION mode. The members in the zoneset become active. 8 Allow access between all the logged-in FC nodes in the absence of active zoneset configuration using the zone default-zone permit command in vfabric CONFIGURATION mode. A default zone advertises a maximum of 255 members in the registered state change notification (RSCN) message. NOTE: The default-zone allows or denies access to the FC nodes when an active zoneset is not available. When the default-zone action is set to permit, the switch allows communication between all the possible pairs of FC nodes. When the default-zone action is not configured, the switch denies any communication between FC nodes. To configure the vfabric on FC interfaces, you need to associate a VLAN ID to the vfabric and add an FC map. See Virtual fabric for more information. Configure FC zoning OS10(config)# fc zone hba1 OS10(config-fc-zone-hba1)# member wwn 10:00:00:90:fa:b8:22:19 OS10(config-fc-zone-hba1)# member wwn 21:00:00:24:ff:7b:f5:c8 OS10(config-fc-zone-hba1)# exit OS10(config)# fc zoneset set OS10(conf-fc-zoneset-set)# member hba1 OS10(conf-fc-zoneset-set)# exit OS10(config)# vfabric 100 Fibre Channel 129