Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.1.0 - Page 138

Parameters Defaults Command Mode Usage Information zoneset-name - Enter an existing zoneset name. Not configured Vfabric CONFIGURATION The no version of this command deactivates the zoneset. After you disable an active zoneset, the zone default-zone permit command configuration takes effect. Based on this configuration, the default zone allows or denies access between all the logged-in FC nodes of the vfabric. Example OS10(config)# vfabric 100 OS10(conf-vfabric-100)# zoneset activate set Supported Releases 10.3.1E or later NPG commands The following commands are supported on NPG mode: fc port-mode F Configures port mode on Fibre Channel interfaces. Syntax Parameters Defaults Command Mode Usage Information Example fc port-mode F None N_Port Fibre Channel INTERFACE Configure the port mode when the port is in shut mode and when NPG mode is enabled. The no version of this command returns the port mode to default. OS10(config)# interface fibrechannel 1/1/1 OS10(conf-if-fc1/1/1)# fc port-mode F Supported Releases 10.4.1.0 or later feature fc npg Enables the NPG mode globally. Syntax Parameters Defaults Command Mode Usage Information feature fc npg None Disabled CONFIGURATION The no version of this command disables the NPG mode. You can enable only any one of the following at a time: F_Port, FIP snooping bridge, or NPG. Example OS10(config)# feature fc npg 138 Fibre Channel