Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.1.0 - Page 421

ip ospf transmit-delay Sets the estimated time required to send a link state update packet on the interface. Syntax ip ospf transmit-delay seconds Parameters seconds - Set the time (in seconds) required to send a link-state update (1 to 3600). Default 1 second Command Mode INTERFACE Usage Information Set the estimated time required to send a link-state update packet. When you set the ip ospf transmitdelay value, take into account the transmission and propagation delays for the interface. The no version of this command resets the value to the default. Example OS10(conf-if-eth1/1/4)# ip ospf transmit-delay 5 Supported Releases 10.2.0E or later log-adjacency-changes Enables logging of syslog messages about changes in the OSPF adjacency state. Syntax log-adjacency-changes Parameters None Default Disabled Command Mode ROUTER-OSPF Usage Information The no version of this command resets the value to the default. Example OS10(config)# router ospf 10 OS10(conf-router-ospf-10)# log-adjacency-changes Supported Releases 10.2.0E or later max-metric router-lsa Configures OSPF to advertise a maximum metric on a router so that it is not desired as an intermediate hop from other routers. Syntax Parameters Default Command Mode Usage Information Example max-metric router-lsa None Not configured ROUTER-OSPF Routers in the network do not prefer other routers as the next intermediate hop after they calculate the shortest path. The no version of this command disables maximum metric advertisement configuration. OS10(conf-router-ospf-10)# max-metric router-lsa Supported Releases 10.2.0E or later Layer 3 421