Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.1.0 - Page 499

Usage Information Example Use this command to configure a range of IPv4 or IPv6 addresses. OS10(config-dhcp-Dell)# network 20.1.1.1/24 Supported Releases 10.2.0E or later pool Creates an IP address pool name. Syntax pool pool-name Parameters pool-name - Enter the DHCP server pool name. Default Not configured Command Mode CONFIGURATION Usage Information Use this command to create an IP address pool name. Example OS10(conf-dhcp)# pool Dell OS10(conf-dhcp-Dell)# Supported Releases 10.2.0E or later range Configures a range of IP addresses. Syntax range {ip-address1 [ip-address2]} Parameters • ip-address1-First IP address of the IP address range. • ip-address2-Last IP address of the IP address range. Default Command Mode Usage Information Example Not configured DHCP-POOL This command is used to configure a range of IP addresses that the OS10 switch, acting as the DHCP server, can assign to DHCP clients. The no version of this command requires only the first IP address to remove the range configuration. OS10(config)# OS10(config)# ip dhcp server OS10(config-dhcp)# pool pool1 OS10(config-dhcp-pool1)# network 192.168.10.0/24 OS10(config-dhcp-pool1)# range 192.168.10.2 192.168.10.8 Supported Releases 10.4.1 or later show ip dhcp binding Displays the DHCP binding table with IPv4 addresses. Syntax Parameters show ip dhcp binding None System management 499