Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.1.0 - Page 633
seq deny ipv6
View all Dell PowerSwitch S4128F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 633 highlights
• A.B.C.D - Enter the IP address in dotted decimal format. • A.B.C.D/x - Enter the number of bits that must match the dotted decimal address. • any - (Optional) Set all routes which are subject to the filter: - capture - (Optional) Capture packets the filter processes. - dscp value - (Optional) Deny a packet based on the DSCP values, from 0 to 63. - fragment - (Optional) Use ACLs to control packet fragments. • host ip-address - (Optional) Enter the IP address to use a host address only. Default Command Mode Usage Information Example Not configured IPV4-ACL The no version of this command removes the filter, or use the no seq sequence-number command if you know the filter's sequence number. OS10(config)# ip access-list egress OS10(config-ipv4-acl)# seq 10 deny ip any any capture session 1 Supported Releases 10.2.0E or later seq deny ipv6 Assigns a filter to deny IPv6 addresses while creating the filter. Syntax Parameters seq sequence-number deny ip [A::B | A::B/x | any | host ipv6-address] [A::B | A:B/x | any | host ipv6-address] [capture | dscp value | fragment] • sequence-number - Enter the sequence number to identify the route-map for editing and sequencing number, from 1 to 16777214. • A::B - Enter the IPv6 address in hexadecimal format separated by colons. • A::B/x - Enter the number of bits that must match the IPv6 address. • any - (Optional) Set all routes which are subject to the filter: - capture - (Optional) Capture packets the filter processes. - dscp value - (Optional) Deny a packet based on the DSCP values, from 0 to 63. - fragment - (Optional) Use ACLs to control packet fragments. • host ip-address - (Optional) Enter the IPv6 address to use a host address only. Default Command Mode Usage Information Example Not configured IPV6-ACL The no version of this command removes the filter, or use the no seq sequence-number command if you know the filter's sequence number. OS10(config)# ipv6 access-list ipv6test OS10(conf-ipv6-acl)# seq 10 deny ipv6 any any capture session 1 Supported Releases 10.2.0E or later Access Control Lists 633