Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.1.0 - Page 252

3 Enter the allowed VLANs on the trunk port in INTERFACE mode. switchport trunk allowed vlan vlan-id Configure port in trunk mode OS10(config)# interface ethernet 1/1/6 OS10(conf-if-eth1/1/6)# switchport mode trunk OS10(conf-if-eth1/1/6)# switchport trunk allowed vlan 108 View running configuration OS10# show running-configuration ... ! interface ethernet1/1/8 switchport mode trunk switchport trunk allowed vlan 108 no shutdown ! interface vlan1 no shutdown ! ... Assign IP address You can assign an IP address to each VLAN to make it a L3 VLAN - the ports in that VLAN belong to that particular IP subnet. The traffic between the ports in different VLANs route using the IP address. Configure the L3 VLAN interface to remain administratively UP or DOWN using the shutdown and no shutdown commands. This provisioning only affects the L3 traffic across the members of a VLAN and does not affect the L2 traffic. You cannot assign an IP address to the default VLAN (VLAN 1). You can place VLANs and other logical interfaces in L3 mode to receive and send routed traffic. 1 Create a VLAN in CONFIGURATION mode (1 to 4093). interface vlan vlan-id 2 Assign an IP address and mask to the VLAN in INTERFACE-VLAN mode. ip address ip-address/prefix-length [secondary] • ip-address/prefix-length - Enter the IP address in dotted-decimal format (A.B.C.D/x). • secondary - Enter the interface backup IP address. Assign IP address to VLAN OS10(config)# interface vlan 200 OS10(conf-if-vl-200)# ip address 10.1.15.1/8 View VLAN configuration OS10(conf-if-vl-200)# do show interface vlan Vlan 1 is up, line protocol is up Address is , Current address is Interface index is 69208865 Internet address is not set MTU 1532 bytes LineSpeed auto Flowcontrol rx off tx off ARP type: ARPA, ARP Timeout: 240 Last clearing of "show interface" counters Queueing strategy: fifo Time since last interface status change: 252 Layer 2