Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.1.0 - Page 437

Supports only single TOS (TOS0) routes It is Flooding according to RFC 2328 SPF schedule delay 1200 msecs, Hold time between two SPFs 2300 msecs Convergence Level 0 Min LSA origination 0 msec, Min LSA arrival 1000 msec Min LSA hold time 5000 msec, Max LSA wait time 5000 msec Number of area in this router is 1, normal 1 stub 0 nssa 0 Area (0.0.0.1) Number of interface in this area is 1 SPF algorithm executed 1 times Supported Releases 10.4.0E(R1) or later timers throttle lsa all Configures the LSA transmit intervals. Syntax timers lsa all [start-interval | hold-interval | max-interval] Parameters • start-interval - Sets the minimum interval between initial sending and re-sending the same LSA in milliseconds (0 to 600,000). • hold-interval - Sets the next interval to send the same LSA in milliseconds. This is the time between sending the same LSA after the start-interval has been attempted (1 to 600,000). • max-interval - Sets the maximum amount of time the system waits before sending the LSA in milliseconds (1 to 600,000). Default . • start-interval - 0 milliseconds • hold-interval - 5000 milliseconds • max-interval - 5000 milliseconds Command Mode Usage Information Example ROUTER-OSPF The no version of this command removes the LSA transmit timer. OS10(config)# router ospf 10 OS10(conf-router-ospf-10)# timers throttle lsa all 100 300 1000 Supported Releases 10.2.0E or later OSPFv3 OSPFv3 is an IPv6 link-state routing protocol that supports IPv6 unicast address families (AFs). OSPFv3 is disabled by default. You must configure at least one interface, either physical or loopback. The OSPF process automatically starts when OSPFv3 is enabled for one or more interfaces. Any area besides area 0 can have any number ID assigned to it. Enable OSPFv3 1 Enable OSPFv3 globally and configure an OSPFv3 instance in CONFIGURATION mode. router ospfv3 instance-number 2 Enter the interface information to configure the interface for OSPFv3 in INTERFACE mode. interface ethernet node/slot/port[:subport] Layer 3 437