Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.1.0 - Page 655
set comm-list add, set comm-list delete
View all Dell PowerSwitch S4128F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 655 highlights
• sequence-number - (Optional) Enter the number to identify the route-map for editing and sequencing number from 1 to 65535. The default is 10. • permit - (Optional) Set the route-map default as permit. • deny - (Optional) Set the route default as deny. Default Command Mode Usage Information Example Not configured CONFIGURATION Use caution when you delete route-maps - if you do not enter a sequence number, all route-maps with the same map-name are deleted. The no version of this command removes a route-map. OS10(config)# route-map route1 permit 100 OS10(config-route-map)# Supported Releases 10.2.0E or later set comm-list add Add communities in the specified list to the COMMUNITY attribute in a matching inbound or outbound BGP route. Syntax set comm-list {community-list-name} add Parameters community-list-name - Enter the name of an established community list (up to 140 characters). Defaults None Command Mode ROUTE-MAP Usage Information In a route map, use this set command to add a list of communities that pass a permit statement to the COMMUNITY attribute of a BGP route sent or received from a BGP peer. Use the set comm-list delete command to delete a community list from a matching route. Example OS10(config)# route-map bgp OS10(conf-route-map)# set comm-list comlist1 add Supported Releases 10.4.0E(R1) or later set comm-list delete Remove communities in the specified list from the COMMUNITY attribute in a matching inbound or outbound BGP route. Syntax set comm-list {community-list-name} delete Parameters community-list-name - Enter the name of an established community list. A maximum of 140 characters. Defaults None' Command Mode ROUTE-MAP Usage Information The community list you use in the set comm-list delete command must be configured so that each filter contains only one community. For example, the filter deny 100:12 is acceptable, but the filter deny 120:13 140:33 results in an error. If you configure the set comm-list delete command and the set community command in the same route map sequence, the deletion command (set comm-list delete) processes before the insertion command (set community). To add communities in a community list to the COMMUNITY attribute in a BGP route, use the set comm-list add command. Access Control Lists 655