Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.1.0 - Page 354

NOTE: To configure these settings for a non default VRF instance, you must first enter the ROUTERCONFIG-VRF sub mode using the following commands: 1 Enter the ROUTER BGP mode using the router bgp as-number command. 2 From the ROUTER BGP mode, enter the ROUTER BGP VRF mode using the vrf vrf-name command. Example OS10(conf-router-bgp-10)# template solar OS10(conf-router-bgp-template)# Supported Releases 10.3.0E or later timers Adjusts BGP keepalive and holdtime timers. Syntax timers keepalive holdtime Parameters • keepalive-Enter the time interval (in seconds) between keepalive messages sent to the neighbor routers, from 1 to 65535. • holdtime-Enter the time interval (in seconds) between the last keepalive message and declaring a router dead, from 3 to 65535. Default Command Mode Usage Information Example keepalive 60 seconds; holdtime 180 seconds ROUTER-BGP The configured timer value becomes effective after a BGP hard reset. The timer values negotiate from peers. The no version of this command resets the value to the default. OS10(conf-router-bgp)# timers 30 90 Supported Releases 10.3.0E or later vrf Enters the CONFIG-ROUTER-VRF command mode. Syntax Parameters Default Command Mode Usage Information Example vrf vrf-name None None ROUTER-BGP This mode enables you to apply BGP configurations to non default VRFs. OS10(config)#router bgp 100 OS10(config-router-bgp-100)# OS10(config-router-bgp-100)#vrf vrf_test1 OS10(config-router-bgp-100-vrf)# Supported Releases 10.3.0E or later 354 Layer 3