Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.1.0 - Page 82
L2 mode configuration
![]() |
View all Dell PowerSwitch S4128F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 82 highlights
Figure 1. S4148U-ON unified port groups To enable Ethernet interfaces in a unified port group: 1 Configure a unified port group in CONFIGURATION mode. Enter 1/1 for node/slot. The port-group range depends on the switch. port-group node/slot/port-group 2 Activate the unified port group for Ethernet operation in PORT-GROUP mode. To activate a unified port group in Fibre Channel mode, see Fibre Channel interfaces. The available options depend on the switch. mode Eth {100g-1x | 50g-2x | 40g-1x | 25g-4x | 10g-4x} • 100g-1x - Reset a port group to 100GE mode. • 50g-2x - Split a port group into two 50GE interfaces. • 40g-1x - Set a port group to 40GE mode for use with a QSFP+ 40GE transceiver. • 25g-4x - Split a port group into four 25GE interfaces. • 10g-4x - Split a port group into four 10GE interfaces. 3 Return to CONFIGURATION mode. exit 4 Enter Ethernet Interface mode to configure other settings. Enter a single interface, a hyphen-separated range, or multiple interfaces separated by commas. interface ethernet node/slot/port[:subport] Configure Ethernet unified port interface OS10(config)# port-group 1/1/13 OS10(conf-pg-1/1/13)# mode Eth 25g-4x OS10(conf-pg-1/1/13)# exit OS10(config)# interface ethernet 1/1/41:1 OS10(conf-if-eth1/1/41:1)# View Ethernet unified port interface OS10(config)# interface ethernet 1/1/41 OS10(conf-if-eth1/1/41:1)# show configuration ! interface ethernet1/1/41:1 no shutdown L2 mode configuration Each physical Ethernet interface uses a unique MAC address. Port-channels and VLANs use a single MAC address. By default, all the interfaces operate in L2 mode. From L2 mode, you can configure switching and L2 protocols, such as VLANs and Spanning-Tree Protocol (STP) on an interface. You can enable L2 switching on a port interface in access or trunk mode. By default, an interface is configured in access mode. Access mode allows L2 switching of untagged traffic on a single VLAN (VLAN 1 is the default). Trunk mode enables L2 switching of untagged traffic on the access VLAN, and tagged traffic on multiple (one or more) VLANs. 82 Interfaces
![](/manual_guide/products/dell-powerswitch-s3048on-os10-enterprise-edition-user-guide-release-10410-b76d862/82.png)