Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.1.0 - Page 326

allowas-in Sets the number of times a local AS number appears in the AS path. Syntax Parameters Default Command Mode Usage Information Example ((IPv4) allowas-in as-number as-number-Enter the number of occurrences for a local AS number, from 1 to 10. Disabled ROUTER-BPG-TEMPLATE-AF Use this command to enable the BGP speaker to allow the AS number to be present for the specified number of times in updates received from the peer. You cannot set this configuration for a peer associated with a peer group. You cannot associate a peer to a peer group that is already configured with an AS number. The no version of this command resets the value to the default. OS10(conf-router-template)# address-family ipv4 unicast OS10(conf-router-bgp-template-af)# allowas-in 5 Example (IPv6) OS10(conf-router-template)# address-family ipv6 unicast OS10(conf-router-bgp-template-af)# allowas-in 5 Supported Releases 10.3.0E or later always-compare-med Compares MULTI_EXIT_DISC (MED) attributes in the paths received from different neighbors. Syntax Parameters Default Command Mode Usage Information always-compare-med None Disabled ROUTER-BGP After you use this command, use the clear ip bgp * command to recompute the best path. The no version of this command resets the value to the default. NOTE: To configure these settings for a non default VRF instance, you must first enter the ROUTERCONFIG-VRF sub mode using the following commands: 1 Enter the ROUTER BGP mode using the router bgp as-number command. 2 From the ROUTER BGP mode, enter the ROUTER BGP VRF mode using the vrf vrf-name command. Example OS10(conf-router-bgp-10)# always-compare-med Supported Releases 10.2.0E or later as-notation Changes the AS number notation format (requires four-octet-assupport). Syntax as-format {asdot | asdot+ | asplain} 326 Layer 3