Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.1.0 - Page 374

Parameters Defaults Command Mode Usage Information Example None None INTERFACE The no version of this command disables the DHCP operations on the interface. OS10(config)# interface mgmt 1/1/1 OS10(conf-if-ma-1/1/1)# ipv6 address dhcp Supported Releases 10.3.0E or later ipv6 enable Enables and disables IPv6 forwarding on an interface configured with an IPv6 address. Syntax Parameters Defaults Command Mode Usage Information ipv6 enable None None INTERFACE • The no version of this command disables IPv6 forwarding. • Use this command to disable and re-enable IPv6 forwarding on an interface for security purposes or to recover from a duplicate address discovery (DAD) failure. Example OS10(config)# interface ethernet 1/1/1 OS10(conf-if-eth1/1/1)# ipv6 address 2111:dddd:0eee::22/128 OS10(conf-if-eth1/1/1)# no ipv6 enable OS10(conf-if-eth1/1/1)# ipv6 enable Supported Releases 10.3.0E or later ipv6 address eui-64 Configures a global IPv6 address on an interface by entering only the network prefix and length. Syntax Parameters Defaults Command Mode Usage Information Example ipv6 address ipv6-prefix/prefix-length eui-64 ipv6-prefix - Enter an IPv6 prefix in x:x::y/mask format. None INTERFACE Use this command to manually configure an IPv6 address in addition to the link-local address generated with stateless autoconfiguration. Specify only the network prefix and length. The 64-bit interface ID is automatically computed from the MAC address. This command enables IPv6 processing on the interface. The no version of this command removes the IPv6 address configuration. OS10(config)# interface mgmt 1/1/1 OS10(conf-if-ma-1/1/1)# ipv6 address 2111:dddd:0eee::/64 eui-64 Supported Releases 10.4.0E(R1) or later 374 Layer 3